Chameleon Articles Directory

Today i write about : Span gas cylinder online shop UK. WSD (weldingsuppliesdirect.co.uk) supplies a wide range of shielding gases specifically designed to optimise performance in particular conditions. In vehicle repair and manufacturing, argon-based gas mixtures are commonly used to MIG weld carbon and low alloy steels. Argoshield Light is one of those choices. It’s ideal if you are welding thinner carbon steel ranging from 0.6 to 5mm in thickness. The addition of oxygen to Argoshield increases arc stability to minimise spatter and fast weld speeds with its low heat input reduce distortion. So it’s perfect for our earlier example where the components of a car are being painted or powder coated after welding.

Overall, argon is a standard, low cost but high-quality choice of shielding to use when welding. Although its odourless and colourless properties make it a convenient gas to use, it can also be dangerous if leaks or overexposure when welding occurs. Never forget that you are dealing with a potentially hazardous element, so entrust installation to a specialist gas installer who knows what they are doing. See extra details on Calibration gas suppliers UK.

Helium / argon mixtures are sometimes used for their higher heat characteristics. Gas mixtures, usually 25% helium and 75% argon are sometimes used and can help to increase travel speeds when AC – gas tungsten arc welding. Mixtures of more than 25% helium for AC – gas tungsten arc welding are used, but not often, as they can tend to produce instability, under certain circumstances, in the AC arc. Pure helium or high percentages of helium (He-90%, Ar-10%) shielding gas are used primarily for gas tungsten arc machine welding with direct current electrode negative (DCEN). Often designed as seam welders, the combination of GTAW – DCEN and the high heat input from the gas used can provide fast welding speeds and outstanding penetration. This configuration is sometimes used to produce full penetration butt welds, welded from one side only, onto temporary baking with no vee-groove preparation, just a square edged plate.

Ozone is only generated during arcing and decays quickly on arc extinction. Therefore, exposure to ozone is very dependent on the duty cycle employed. Although research in the laboratory has shown that ozone concentrations at points around a welding arc can exceed 0.2ppm, it is uncommon to find that average exposure to ozone, in a real work situation, exceeds the ozone exposure limit. An exception to this statement is exposure to ozone during MIG welding with an aluminium/silicon consumable.

The primary task of a shielding gas is to protect the weld pool from the influence of the atmosphere, i.e. from oxidation and nitrogen absorption, and to stabilize the electric arc. The choice of shielding gas can also influence the characteristics of the weld penetration profile. The basic gas for MIG/MAG welding is argon (Ar). Helium (He) can be added to increase penetration and fluidity of the weld pool. Argon or argon/helium mixtures can be used for welding all grades. However, small additions of oxygen (O2) or carbon dioxide (CO2) are usually needed to stabilize the arc, improve the fluidity and improve the quality of the weld deposit. For stainless steels there are also gases available containing small amounts of hydrogen (H2).

Quad gases are mainly used within Marine environments. Quad gases are a four gas mix. Supplied in a range of lightweight cylinders and made from aluminum. Both reactive and non-reactive mixtures are available. Source: https://www.weldingsuppliesdirect.co.uk/industrial-gas/specialist-gases.html.